In EPOS Manager, you can assign different floor plans or table layouts to individual terminals, allowing each till to reflect its specific area or setup.
⚠️ Important: This configuration can be done either on the till using Program Mode or through EPOS Manager. If you do not have access to either option, log a case so our support team can assist you.
On the Till (PosLink)
Log onto the terminal.
Click Program Mode and select Programming/Program Options.
Click Terminal Configuration.
Locate Default Floor Plan Level at the bottom of the left-hand page and select the desired layout from the dropdown.
Click Save.
📌 Note: Repeat these steps on each terminal to assign unique floor plans as needed.
Through EPOS Manager
Log in to EPOS Manager.
Go to System Maintenance and then Locations.
Select the relevant location.
Open the Tills tab and click Edit for the desired till.
Locate Default Floor Plan Level and select the desired layout.
Save your changes and send them to the terminal.